Sometimes increasing the ratio adds that aggression and punch you’re after. The key is to experiment with attack and even ratio to highlight transients rather than pushing them down. Instead, you’ll want to opt for a medium-slow attack to retain the fastest transients on certain parts of the kit. If you set the attack time too fast, you’ll end up squashing these and sucking the life right out of them. It will ultimately determine how much “punch” you’re going to get out of them, which roughly translates to how hard they hit and how exciting they sound.ĭrums have a lot of really fast transients in the kick and snare. Attack Time Mattersįor heavier drum compression, the attack time is one of the most important parameters. Now, the rest of the settings are vital since you’re imparting much more of the compressor’s sound on the drums. Somewhere in the range of 3-6 dB of gain reduction is a good place to aim. When you need the kick and snare to be aggressive and cut through, more compression does the trick. At 1-2 dB of gain reduction, attack and release aren’t nearly as important as they are with heavier compression. With such minimal compression going on, the actual setup of the compressor is less crucial. Keep in mind that a ratio of 2:1 retains the most punch because it acts on transients less. Even just a dB or 2 of gain reduction at a 2:1 ratio can sound incredible. With a fantastic drummer, kick and snare will still benefit from a little bit of compression.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |